Maintenance - Truma MonoControl Mode D'emploi

MonoControl
Disconnect the low-pressure section from the high-pressure sec-

tion� To do this, use the T20 Torx pin of the screw aid to turn the
black reset button in a clockwise direction until the reset button
jumps out�
Unscrew the screw cap of the test connection�

Connect the regulator test appliance with the test hose to the test

connection�
Check for leaks in accordance with the national regulations

(e�g� 607 in Germany)�
Unscrew the regulator test appliance from the test connection�

Screw the screw cap back onto the test connection�

Press the black reset button with the T20 Torx pin of the screw aid

in the housing and gently turn in an anti-clockwise direction�
Abb� 8
1 Screw aid with Torx pin T20
2
Reset button
3 Screw cap
6

Maintenance

The gas pressure regulator is maintenance-free�
Do not remove covers on the gas pressure regulator under any

circumstances�
If in doubt, contact Truma Service�

50020-00982 ∙ 00 ∙ 08/2022
2
1
Maintenance
3
EN 49