Truma MonoControl Mode D'emploi page 35

MonoControl
Avoid using external undue force on the gas pressure regulator,

since this may lead to malfunctions�
Do not impede the reset button's movement using objects�

2.1.2 Component installation and connection
Component connections may be leaky if they are incorrectly installed,
damaged or dirty�
Use a high-pressure hose under all circumstances for high-pres-

sure connections between the gas cylinder and the gas pressure
regulator or gas filter�
When connecting the high-pressure hose, ensure that the seal on

the hose outlet is present and undamaged�
Securely fasten all parts to stable structures to prevent damage

due to vehicle vibrations while driving�
Replace gas hoses immediately if they have been completely or

partially damaged or were changed in any way�
Keep connections free from dirt�

2.1.3 Handling liquid gas
The use of upright gas cylinders from which gas is extracted in the
gas phase is mandatory when operating the gas pressure regulator�
If a gas cylinder is on its side, liquid can penetrate low-pressure
parts, damage sensitive parts and lead to dangerous gas leaks� Gas
cylinders from which gas is taken in the liquid phase (e�g� for fork
lifts) must not be used, since they would result in damage to the gas
system�
Only use gas cylinders in an upright position�

Do not use gas cylinders that provide gas from the liquid phase�

Gas cylinders that are not connected to the gas system must be

closed at all times and provided with protection caps�
 Connected gas cylinders are considered to be operating materials
and not hazardous materials (ADR exemption in accordance with
sections 1�1�3�1 and 1�1�3�2 e)�
50020-00982 ∙ 00 ∙ 08/2022
Safety
EN 35