Changing The Gas Cylinder - Truma MonoControl Mode D'emploi

Operation
4.3

Changing the gas cylinder

Use the included screw aid to attach and remove the high-pressure
hose� The screw aid helps you generate the necessary tightening
torque and prevents damage to the union that may otherwise result
from using an improper tool�

WARNING
Risk of fire and explosion hazard due to residual gases
Residual gases may escape and form a flammable gas mix-
ture with the air when the cylinder is changed�
Do not use any naked flames or open fire�

Do not smoke�

4.3.1 Gas cylinder with cylinder valve
Close the cylinder valve of the empty gas cylinder�

Unscrew the high-pressure hose from the cylinder valve with the

screw aid�
Replace the gas cylinder�

Screw the high-pressure hose onto the cylinder valve of the full

gas cylinder with the screw aid�
If a gas filter is present, change the filter pad (see the operating

instructions for the gas filter)�
Open the cylinder valve of the full gas cylinder�

If available, press the hose rupture protection on the high-pres-

sure hose�
If necessary, press the black reset button on the gas pressure

regulator and gently turn in an anti-clockwise direction�
After any intervention, check the hose connection on the cylinder

valve for leaks (see the "Checking for leaks in the high-pressure
section" chapter)�
During a cylinder change, ensure that the high-pressure hose

from the inlet connection of the gas pressure regulator is always
at a constant gradient to the gas cylinder (Fig� 7)�
44 EN
MonoControl
50020-00982 ∙ 00 ∙ 08/2022