Truma MonoControl Mode D'emploi page 46

Operation
High-pressure hoses must be replaced before their expiry date

elapses or when they are damaged�
Store high-pressure hoses in a dark and dry place�

Observe national and local regulations�

Use the supplied screw aid to change the high-pressure hose�

The required tightening torque is achieved with the screw aid�
Damage to the bolted connections caused by unsuitable tools is
thus avoided�
Never use hose clips because this can cause damage and leaks in

high-pressure hoses�

WARNING
Risk of fire and explosion hazard due to residual gases
Residual gases may escape and form a flammable gas mix-
ture with the air when the high-pressure hose is changed�
Do not use any naked flames or open fire�

Do not smoke�


WARNING
Risk of fire and explosion hazard due to damaged or
missing seal
Check the flat gasket during each high-pressure hose

change and replace it if it is ageing, hardening, cracking
or exhibits other visible defects�
Never use self-made seals; instead, only use Truma

original spare parts�
Ensure that the seal is available and properly installed�

It is advisable to replace the flat gasket G�13 (see chapter

„Accessories") during each hose change�
Close the cylinder valve of the gas cylinder�

Disconnect the high-pressure hose from the cylinder valve or clip-

on adapter� Observe the direction of rotation (left-hand thread)�
46 EN
MonoControl
50020-00982 ∙ 00 ∙ 08/2022