Russell Hobbs RHCP 021 Mode D'emploi page 7

ASSEMBLY INSTRUCTIONS
1. Unplug from outlet before assembly or disassembly of parts. Attach the Cam Shaft to
the Press Disc by inserting the stem of the Shaft into the Press Disc's centre hole.
Press firmly. You will hear a click as the Shaft snaps in place. (See Figure 4)
2. Line the tabs on the Motor Body up with the slots on the Cam Disc. Insert Cam Disc
into the Motor Body. Using the two grips on the Cam Disc, turn slightly clockwise until
the Disc clicks into position. (See Figure 5)
3. Fit the Shaft all the way inside the unit, the outside contours of the 2 Discs will line
up. (See Figure 6).
NOTE: Turn Cam Disc one click counter clockwise if Shaft is difficult to insert
into Motor Body.
Figure 6
4. Select a Disc and place it inside the Tube Cover, then place the Tube into the Tube
Cover, turning clockwise until locked. (See Figure 7)
5. If a Filler Tip or Decorator Tip is used, fit the desired Tip over the Filler/Decorator Tip
Adapter and secure it with the Filler Tip/Decorator Tip Cover. Place the Filler Tip
Assembly inside the Tube Cover. Place the Tube into the Tube Cover and turn
clockwise until locked. ( See Figures 8A and 8B)