Table des Matières
Publicité
• Track guide wear: Check wear on track guides. Refer to the
"Wear" section of the User Manual on page 52. Replace
guides if wear is too great.
• Stabilizers: Verify condition of rubber cones on the stabilizer
assembly of front systems and wheel axle assembly of rear
systems. If the cone bores show oval-shaped wear, they
must be replaced.
• Cracks: Visually inspect the frames for presence of cracks or
defects that can impair proper operation of the systems.
Replace components if damaged.
Sprocket
• Wear: Check wear of sprockets on the systems. Refer to the
"Wear" section of the User Manual on page 53. Replace if
wear is too great.
Anti-rotation
• Lubrication: The maintenance chart recommends cleaning
and lubricating the anti-rotation arms. Refer to the
"Lubrication" section of the User Manual on page 48.
• Bolt torque: Verify torque of assembly bolts on anchor
brackets and anti-rotation arms at the recommended intervals
specified by the maintenance chart.
• Cracks, bent parts: Visually inspect anti-rotation arms for
presence of cracks or bent parts that can impair proper
functioning. Replace components if damaged.
MAINTENANCE SCHEDULE
38
Publicité
Table des Matières
