Table des Matières
Publicité
• Loosen jam nut (1). Adjust length of rod end (2) by
rotating the stabilizing arm (3) to obtain 270 mm
[10 5/8 in] above the ground. Refer to Figure 6.
NOTE: Before each measurement, temporarily apply light pressure to
the front of the track to make sure that it stays flat on the ground.
.
Figure 6
• When angle of attack is correctly set, tighten the jam
nut (1) back against the stabilizing arm. See Figure 7.
Figure 7
ADJUSTMENTS
20
Publicité
Table des Matières
