Installation, Removal And Re-Installation - Polaris PROSPECTOR PRO 2014 Manuel De L'utilisateur

INSTALLATION, REMOVAL AND RE-INSTALLATION

INSTALLATION, REMOVAL
AND RE-INSTALLATION
Never place body parts under the vehicle unless it is
securely placed on appropriate stands. Severe injuries
could occur if the vehicle collapses or moves. Do not use a
lifting device as a secure stand.
Always follow good shop practices. The place where you will be
working must be security, clean, bright and well ventilated. If
you are to use a floor jack, never use it as a stand. Always use
appropriate stands. To avoid vehicle movement during
operations, place blocks behind wheels that remain in contact
with the ground. These recommendations also apply when
removing parts.
Before beginning the installation, ensure you that the
vehicle is immobilized and that the engine is stopped.
To avoid any potential burn injury, allow the engine and
exhaust pipes to cool before beginning installation of the
system.
Read this manual before proceeding with the installation
work. Read the "Installation Guidelines" included with the
System for installation instructions dedicated to your ATV
model.
When the system is removed and when the wheels are
reinstalled on vehicle, make sure that you reinstall all the
components of origin (wheels, guards, etc.) such as they
were in the initial condition on the vehicle.
WARNING
WARNING
WARNING
14