Table des Matières
Publicité
Maintenance - Tasks
• Inspect: Component(s) must be examined with care. If an
anomaly is noticed, the malfunctioning component(s) must be
repaired or replaced.
• Clean: Component(s) must be cleaned of any dirt, dust or
contaminant liable to impair the proper operation of the track
system.
• Adjust: Component(s) must be adjusted or re-adjusted
according
recommendations. Refer to the relevant section of the User
Manual.
• Lubricate: Component(s) need to be lubricated according to
the manufacturer's recommendations. Refer to the relevant
section of the User Manual.
• Replace: Component(s) must be replaced to avoid serious
breakage.
Maintenance - Specifications
System
• Visual inspection: Visually inspect each track system to
detect any defect or anomaly that can impair proper
functioning of the systems.
• Adjustment : Perform or verify the attack angle adjustments
on
the
systems
recommendations. Refer to the "Adjustments" section of the
User Manual on page 18.
• Vehicle alignment: Make or verify the adjustments (vehicle
alignment) on the systems according to the manufacturer's
recommendations. Refer to the "Alignment" section of the
User Manual on page 26.
• Bolt torque: Check the torque of critical bolts identified in the
exploded views of the system. Refer to the central pages of
the User Manual.
NOTE: Comply with the tightening torque recommendations and use
threadlocker liquid if you come across a bolt not tightened to the
manufacturer's recommendations.
MAINTENANCE SCHEDULE
to
the
manufacturer's
according
to
adjustment
the
manufacturer's
36
Publicité
Table des Matières
