Connection Of The Power Supply; Connection Drawing Clamp Description - Biral AX RED Serie Instructions D'installation Et D'entretien

98 english
|

5.2 Connection of the power supply

The pump must be protected on-site (10 A, slow) and must be connected to an external
mains switch. All cables used must have a heat resistance of up to 85 °C.
They must not be in contact with the pipe or the pump and motor casing.
All cables must be connected in accordance with EN 60204-1 and EN 50174-2: 2000.
The electrical connection must be made as indicated on the nameplate.
AX...
AX 15-0.7 BLUE RV KH
AX 15-1.6 BLUE RV KH
AX 15-2.5 BLUE RV KH
AX 20-0.8 120 BLUE
AX xx-3... RED
AX xx-4... RED / BLUE
AX xx-6... RED / BLUE
Example of a typical mains connection, 1x230V +6/-10%, 50 / 60Hz
L
N

5.3 Connection drawing Clamp description

Legende:
N L
1 Sicherung (min.10A, träge)
2 Externer Schalter
AC in
~1x230V +6/-10%
50/60 Hz
Protection
1
(10A, inert
FI
Ratet current [A]
0.05 – 0.07
0.08 – 0.15
0.13 – 0.26
0.04 – 0.08
0.05 – 0.18
0.05 – 0.19
0.05 – 0.38
external 2
switch
96200007_00
961906_00
Power P [W]
1
5 – 8
9 – 18
14 – 30
4 – 7
4 – 21
5 – 22
5 – 45
Mains connection:
1x230V +6/-10%, 50/60Hz
Terminals:
L, N, PE Mains connection