Additional Technical Data - Hilti DSH 600-X Mode D'emploi Original

3.5 cut-off wheel specifications
Diamond wheels in accordance with EN 13236 are to be used with the product. Synthetic resin-bonded,
fiber-reinforced cut-off wheels in accordance with EN 12413 (straight, not dish-shaped, type 41) may also
be used with the product for working on metals.
The wheel mounting instructions and instructions for use issued by the cut-off wheel manufacturer must be
observed.
3.6 Items supplied
DSH 600-X gasoline-powered saw, tools set, DSH 600-X wear parts and consumables set, operating
instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
3.7 Saw blade brake
The product is equipped with an integrated saw blade brake to increase operator safety.
The saw blade is braked to a standstill in a maximum of 10 seconds after the throttle safety grip is released.
Releasing the throttle safety grip when the tool is running at full speed causes the tool to flick forward
slightly because of the braking torque. So hold the tool firmly with both hands on the grips provided.
3.8 Consumables and wearing parts
• Air filter
• Cord
• Starter
• Fuel filter
• Spark plug
• Tool set
• Cylinder set
• Mounting screw assy.
• Flange for abrasive cut-off wheel (with integral centering ring 20 mm/1")
• Flange for diamond cut-off wheel (with integrated centering ring 20 mm/1")
4 Technical data
4.1 Gasoline-powered cut-off saw
Engine displacement
Weight with diamond wheel flange, without cut-off wheel,
tank empty
Rated power at 8500 rpm in accordance with ISO 7293
Maximum spindle speed
Max. rotational speed of the cut-off wheel
Maximum cutting depth
Carburetor
4.2

Additional technical data

Engine type
Maximum engine speed
Idle speed
Ignition (type)
*2316321*
2316321
DSH 600-X
63.3 cm³
9.85 kg
3.2 kW
5,080 /min
5,080 /min
120 mm
Walbro; model: WT-1203
DSH 600-X
Single-cylinder, air-cooled two-
stroke engine
8,700 /min
2900 ± 200 /min
Electronic
English 27