Manufacturer's Warranty - Hilti DSH 600-X Mode D'emploi Original

Trouble or fault
Low engine power / poor
cutting performance
cut-off wheel rotates while
the engine is idling.
cut-off wheel doesn't rotate.
Starter assembly doesn't
work.
Saw blade rotates for longer
than 15 seconds after the
throttle safety grip is
released.
10 Disposal
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative for further information.
Drilling slurry
Disposal of drilling slurry directly into rivers, lakes or the sewerage system without suitable pretreatment
presents environmental problems.
▶ Ask the local public authorities for information about current regulations.
We recommend the following pretreatment:
▶ Collect the drilling slurry (for example, using a wet-type vacuum cleaner).
▶ Allow the drilling slurry to settle and dispose of the solid material at a construction waste disposal site
(addition of a flocculent may accelerate the settling process).
▶ The remaining water (alkaline, pH value greater than 7) must be neutralized by the addition of an acidic
neutralizing agent or diluted with a large volume of water before it is allowed to flow into the sewerage
system.
11

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
*2316321*
Possible cause
Wrong fuel mixture.
The cut-off wheel specification is
unsuitable for the material to be
cut.
Drive belt or cut-off wheel slips.
Engine compression is too low.
The product is used at an altitude
greater than 1500 meters above
sea level.
Incorrect carburetor setting (fuel /
air mixture).
Idling speed is too high.
The half-throttle position is en-
gaged.
Faulty centrifugal clutch.
Inadequate drive belt tension or the
drive belt is broken.
The clutch claws are not engaging.
Brake strap is worn.
Action of Bowden cable for brake
is stiff.
2316321
Action to be taken
▶ Empty the fuel tank and flush
out the tank and fuel supply line.
▶ Fill the fuel tank with the correct
fuel.
▶ Change the cut-off wheel or
consult Hilti Service.
▶ Check that the cut-off wheel is
clamped securely.
▶ Have the product repaired by
Hilti Service.
▶ Check the engine compression
and, if necessary, replace worn
parts (piston rings, piston,
cylinder, etc.).
▶ Have the carburetor adjusted
by Hilti Service.
▶ Have the carburetor adjusted
by Hilti Service.
▶ Check the idling speed and
adjust it if necessary.
▶ Release the half-throttle posi-
tion.
▶ Change the centrifugal clutch.
▶ Have the product repaired by
Hilti Service.
▶ Clean the clutch claws so that
they move freely.
▶ Have the product repaired by
Hilti Service.
▶ Have the product repaired by
Hilti Service.
English 39