Hilti DSH 600-X Mode D'emploi Original page 39

12. Remove the locking pin.
CAUTION
Risk of injury and damage. Damaged accessory tools can break.
▶ Never use an accessory tools that is damaged, runs out of true or vibrates.
▶ Keep clear of the danger zone.
13. After fitting a new cut-off wheel, run your product at full speed under no load for approximately 1 minute.
5.2.2 Adjusting the guard
WARNING
Risk of injury. Contact with the cut-off wheel, flying fragments or sparks can cause injury to persons.
▶ Adjust the guard so that flying particles or fragments of the material removed and flying sparks are
directed away from the operator and the product.
▶ Hold the guard by the grip provided and rotate it to the desired position.
Make sure that the opening of the blade guard is not toward the user.
5.2.3 Fitting the water pump (accessory)
1. Switch the product off.
2. Release the three pump cover retaining screws, remove the parts and store the pump cover in a safe
place.
The pump cover must be fitted if the tool is used without the water pump.
3. Hold the water pump in position and turn the cut-off wheel slightly to bring the splines of water pump
and clutch bell into alignment so that the splines engage.
▶ The position is keyed so it is not possible to position the pump incorrectly.
4. Install the three securing screws and tighten the securing screws.
▶ Tightening torque: 8 Nm
5. Connect the pump hose to the hose connector on the saw.
6. Remove the protective cap from the end of the water connection hose.
7. Make sure that the water pressure in the water supply line is max. 6 bar.
▶ Reduce the water pressure as necessary.
8. Connect the water pump to the water supply or immerse the end of the suction hose in a container filled
with water.
Fit the protective cap to the end of the water connection hose when the water pump is not
connected to a water supply.
5.2.4 Removing the water pump (accessory)
1. Switch the product off.
2. Disconnect the water supply from the water pump.
3. Fit the protective cap to the end of the water connection hose.
4. Disconnect the connector between the pump and the tool.
5. Release the three fastening screws on the pump and then remove the pump.
6. Place the pump cover in position.
7. Install the 3 securing screws and tighten the securing screws.
▶ Tightening torque: 4 Nm
5.2.5 Fitting the wheel set (accessory)
1. Slacken the two bottom securing screws on the metal guard.
2. Secure the base plate with the two screws.
3. Secure the wheels and washers with the screws on both sides of the base plate.
*2316321*
5
6
2316321 English 31