Accessories; Technical Data - Hilti WSC 70-A36 Mode D'emploi

3 Accessories

Accessories for the WSC 70‑A36
Designation
Charger
Charger for Li-ion batteries
Charger for Li-ion batteries
Charger for Li-ion batteries
Battery
Battery
Battery
Parallel guide (rip fence)
Guide rail

4 Technical data

Right of technical changes reserved.
Power tool
Rated voltage (DC voltage)
Weight in accordance with EPTA procedure 01/2003
Dimensions (L x W x H)
Base plate
Maximum saw blade diameter
Minimum saw blade diameter
Saw blade disc thickness
Kerf width
Saw blade arbor size
Cutting depth
Riving knife thickness
Speed under no load
NOTE
The vibration emission level given in this information sheet has been measured in accordance with a standardised test
given in EN 60745 and may be used to compare one tool with another. It may be used for a preliminary assessment
of exposure. The declared vibration emission level represents the main applications of the tool. However if the tool is
used for different applications, with different accessories or poorly maintained, the vibration emission may differ. This
may significantly increase the exposure level over the total working period. An estimation of the level of exposure to
vibration should also take into account the times when the tool is switched off or when it is running but not actually
doing the job. This may significantly reduce the exposure level over the total working period. Identify additional safety
measures to protect the operator from the effects of vibration such as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.
Noise and vibration information for the WSC 70-A36 (measured in accordance with EN 60745-2-5):
Typical A-weighted sound power level
Typical A-weighted emission sound pressure level.
Uncertainty for the given sound level
Short designation
C7/36-ACS
C4/36-ACS
C 4/36‑90
C 4/36‑350
WSC 70‑A36
36 V
5.8 kg
393 mm x 233 mm x 307 mm
193 mm x 320 mm
190 mm
176 mm
0.5...1.4 mm
1.6...2.2 mm
30 mm
Cutting angle 90°: 70 mm
Cutting angle 50°: 45 mm
Cutting angle 45°: 51 mm
1.5 mm
4,000/min
108 dB (A)
97 dB (A)
3 dB (A)
Description
B36/2.4 Li‑ion
B36/3.3 Li‑ion
B36/3.9 Li‑ion
WPG 370/355
WGS 1400‑2B
en
19