Textron RANSOMES Frontline 951 Plus Mode D'emploi page 14

ASSEMBLY AND SETUP
GB
5. Level cutter deck.
a) Place cutter deck in lowest cutting position. See ADJUSTMENTS section.
b) Place (2) 1.00" (25.4 mm) blocks A under the rear of the deck.
c) Note the position of the hanger pins S, they should just touch the hanger T. If not, loosen nut that
holds hanger and slide it until it contacts the pin S. Torque to 85 ft-lbs.
6. Install one end of the 5/8 I.D. hose R to the
port on the tractor frame labeled
(PRESSURE) (left side when standing in
front of tractor) and the other end to the
cutter deck motor port S.
GB-12
RANSOMES Frontline 951 Plus
OPERATORS MANUAL