Table des Matières
Publicité
1
46
2
5.1-5
5.1-6
4
4A
Operations
5.1.2 Locking the wheel
Figure 5.1.-4
•
Rotate the rim on the tyre changer Flange until
the driving pin 1 is inside one of the rim concentric
holes.
•
Centre the wheel on the relevant support plate.
•
Insert the locking tool (2) in the middle of the rim
and push it down.
•
Press the pedal (3) Fig. 5.1-6 and lock the tool
on the rim.
•
On the tool there is a locking indicator (4). Such
indicator is "DOWN" when the wheel is released
and "UP" - thus uncovering the red indicator (4A)
- when the wheel is locked correctly. During the
locking phase, keep the tool pressed and press
the pedal until locking the tool.
The wheel will be locked and ready for the
Tyre Mounting/Demounting operations.
Always lubricate the contact surface between tyre
and rim, on both of them.
In case the wheel locking procedure was interrupted,
to restart it press pedal (3)
twice.
Publicité
Table des Matières
Dépannage
