Specifications According To The Model; Installation And Safety Instructions - Bronpi SIERRA Instructions D'installation, D'utilisation Et D'entretien

3.

SPECIFICATIONS ACCORDING TO THE MODEL

Model Fígaro
In order to open the door of the combustion chamber, it is necessary to press downwards the small handle placed in the right side.
The door has a self-closing device and along the use it may lose effectiveness. To adjust the automatic closing of the door, it is necessary to
adjust the regulator placed in the back part of the model. Note, that when you turn this regulator clockwise, the spring receives more tension
and the door lock is easier.
In order to open the oven door, it is necessary to use the space in the side of the door and pull it.
WARNING!! In both cases, if the fire is lit, we recommend that you use the thermal glove incorporated in order to use the
regulations and avoir burns.
4.

INSTALLATION AND SAFETY INSTRUCTIONS

The way of installing the oven will affect the safety and the proper operation. For this reason, it is recommendable that the installation is
carried out by people who are qualified and informed about the compliance with the installation and safety norms.
If an oven is not properly installed, it may cause serious damage.
Before the installation, follow the next verifications:
• Make sure that the floor can sustain the weight of the equipment and make a proper isolation in the case that it is made of flammable
material (wood) or a material that can be affected by a thermal shock (plaster cast, for example).
• If the equipment is installed on a floor which is not completely refractory or inflammable such as parquet, carpet, etc, it is necessary to
replace this part or introduce a fire-resistant base so that it protrudes out the oven 30 cm. Example of materials include steel flooring,
glass base or any other type of fire-resistant material.
• Make sure that there is proper ventilation in the place where it is installed (air intake) (see section 5 of the manual).
• Avoid the installation in places where there are collective ventilation pipes, hoods with or without extractor, B type gas equipments,
heat pumps or equipments that can cause that the draw is not good if they are used at the same time.
• Make sure that the smoke duct and the pipes used for the chimney are suitable for the operation of the oven.
We recommend that you call your fitter in order to check both the chimney as well as the air flow for the combustion.
This product can be installed near the walls as long as they comply with the following requirements:
The fitter must assure that the wall is completely made of brick masonry, thermo-clay block, concrete, bricks, etc, and that it is coated by
materials that can support high temperature.
Therefore, for any other type of material (drywall, wood, non-ceramic glass, etc), the fitter must provide sufficient insulation or keep a
minimum safety distance to the wall of 80-100 cm.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
D15
D16
D17
17 OVENS