Oven - Bronpi SIERRA Instructions D'installation, D'utilisation Et D'entretien

Baffle plate
The models Mónaco and Fígaro have a baffle plate that consists of a fundamental part for the proper operation of the stove. It must be placed
in the right position and must not be used without the baffle plate. This would invalidate the warranty.
The combustion is not always stable. In fact, it can be affected by the weather conditions or the outside temperature. This modifies the draw
of the chimney. For this reason, this model have a baffle plate.
WARNING!
The lack of the baffle plate causes an excessive draw. This causes a
fast combustion, excessive wood consumption and the overheating
of the equipment.
Due to safety reasons during the transport, the baffle plate is not assembled. You
will find it inside the combustion chamber. To place it properly, follow the next steps:
The baffle plate must be rested on the side supports of the combustion chamber
and you have to fit on the groove where the air of the double combustion goes off
(see drawing D5).
NOTE: The rest of the models do not have baffle plate
2.1.

OVEN

It is located on the top of the model and it has an airtight cooking chamber. The base
of the oven is made of refractory brick (it absorbs heat and irradiates it). Heating is
produced when the smoke passes through the sides and the upper part of the oven.
On the top of the oven there is one pipe that connects the cooking chamber with the
smoke outlet in order to remove the gas generated in the oven (see drawing D6).
The oven has the following components:
- Thermometer: it is disassembled and you can find it in the baking tray. It shows
the cooking temperature of the oven. To install it, it is necessary to introduce the sheath through the hole of the door and, then, put the nut
(see drawing D7 and D8).
NOTE:The models Mónaco and Fígaro have a bimetallic thermometer placed on the glass of the oven. To install it, it is necessary to
introduce the thermometer through the hole of the door and, then, put the rubber and the nut on the backside (see drawing D9).
WARNING!! The thermometer shows the cooking temperature of the oven. It never shows the temperature of the
combustion chamber. The maximum cooking temperature for the oven is 200-230ºC. If the thermometer shows that the
oven reaches a higher temperature, this means that the equipment has been overloaded and this will invalidate the
warranty.
- Trays. There are two trays and they are made of stainless steel. They can be adjustable in two different
levels according to the slot that we use. In order to avoid the damage of the trays, it is recommended to
extract them outside the oven when they are not being used (see drawing D10).
NOTE: The models Mónaco and Fígaro only have one tray and the model Figaro only has one height.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
D7
15
D8
D9
D5
D6
D10
OVENS