Ignition And Normal Operation; Servicing And Care; Anti-Soot Registers - Bronpi SIERRA Instructions D'installation, D'utilisation Et D'entretien

• The equipment, at the beginning, must be subject to different start-up cycles so that all materials and the paint can complete different
elastic expansions.
Therefore, it is important to adopt these measures during the ignition phase:
1. Assure that there is a good air refill in the place where the equipment is installed.
2. During the 4 o 5 first ignitions, do not load excessively the combustion chamber and keep the oven lit during at least 6-10 hours
continuously.
3. Then, load it more, respecting the recommended load and try to leave the fireplace lit the maximum time as possible, trying to avoid
short ignition periods.
4. During the first ignitions, you should not place any object on the equipment and, in particular, on lacquered surfaces. Lacquered
surfaces should not be touched while the equipment is heated.
9.

IGNITION AND NORMAL OPERATION

In order to do a good ignition of the fireplace, it is necessary to follow the next steps:
a. Open the door. Open completely the regulator of the primary air intake and the regulator of the secondary air intake. (in the models
which are adjustable, see section 2)
b. Insert a fire starter or a paper ball and some wood splinters into the chamber.
c. Light the paper or the splinter. Close the door slowly and leave it half-open 10 or 15 minutes while the glass is heated.
d. When there is flame enough, open the door slowly in order to avoid smoke returns and load the fireplace with dry wood logs. Close the
door slowly.
e. When the logs are lit, use the regulators located on the frontal part (primary and secondary air intake) in order to control the heat
emission of the fireplace. These regulators should be opened according to the heating needs. The best combustion (with minimum
emissions) is reached when the main part of the air for the combustion passes through the secondary air regulator.
In addition to the air regulation for the combustion, the draw also affects the intensity of the combustion and the heating performance of your
equipment. A good draught of the fireplace needs a reduced regulation of the air for the combustion, while a lack of draught needs a good
regulation of the air for the combustion.
Due to safety reasons, the door must remain closed when the fireplaces is being used. You should only open the door for loading the
fuel.
In order to refill the fuel, open the door slowly, open the primary air intake, introduce the wood and close the door. After 3-5 minutes, return to
the combustion recommended regulation.
Do not overload the equipment (see maximum fuel load). Too much fuel and too much air for the combustion can cause the
overheating and, therefore, damage the equipment. The non-compliance of this rule shall invalidate the warranty.

10. SERVICING AND CARE

The fireplace, the chimney and, in general, the whole installation, must be cleaned completely at least once a year or when necessary.
WARNING!! Maintenance and servicing operations must be done when the oven is cold.
These tasks are not covered by the warranty.
10.1.

ANTI-SOOT REGISTERS

All ovens, over time and with the use, can create soot deposits in the external parts of the cooking oven. These deposits can obstruct the
draw and cause a malfunction of the equipment. Therefore, Bronpi ovens incorporate a removable register on the front, above the cooking
chamber, which allows the cleaning of such deposits. The register is hidden under the logo of the oven door.
This task must be done at least 2-3 times a year (according to the use).
Models Sierra, Sierra-E and Sagra
It is necessary to unscrew the logo and use the hole in order to proceed with the cleaning (see drawing D24).
When you are cleaning the oven, please be careful and do not use aggressive products because they can wear down the
paint and too much water can oxidise it.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS 21
D24
OVENS