Specifications According To The Model; Huelva-C; Important - Bronpi LORCA-R Instructions D'installation, D'utilisation Et D'entretien

entry air inside the combustion chamber.
This allows a second combustion of the gases not burnt in the first combustion that
achieves a high performance efficiency, a great fuel saving and reductions in pollutant
emissions. (see drawing D2.12)
2.1.

SPECIFICATIONS ACCORDING TO THE MODEL

2.1.1.

HUELVA-C

The Huelva-C model is intended for installation suspended or hung on a stable roof (with sufficient load capacity).
IMPORTANT!!!: Before proceeding with the assembly of this appliance, make sure that the ceiling
where you want to install the appliance is capable of supporting its weight. If the appliance is not fixed
correctly it may fall. All fasteners must be properly mounted, the installer will be responsible for the
installation to be carried out and ensure that the device is properly suspended.
Due to the weight of the device, at least 2 people are needed to move and install the device. If convenient, use
appropriate auxiliary means to facilitate both operations.
D2.14
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
D2.11
"Cold hands" handle (Models: Lorca-R, Huelva-C and Huelva)
Inside the ash pan you will find the "cold hands" handle in order to open the
door. In order to place it properly, it is necessary to introduce it from top to
bottom and, later, rotate it (see drawing D2.11).
Double combustion
Some models of the metallic
fireplaces include a double
combustion. With this system
we get a second preheat
To proceed with the installation of this fireplace, you must follow the next
steps:
- First, you must screw the telescopic part of the flue cover to the
ceiling (see drawing D2.13). Along with the chimney, 4 tilting blocks
with their respective clamping nuts are supplied. The supplied plugs are
suitable for solid masonry, for other types of constructions (for example
plasterboard, polystyrene vaults, etc.), the installer must use appropriate fixing means.
- Subsequently, you must position the chimney in the chosen place, determine the height
of the fireplace above the floor using the appropriate auxiliary means, and proceed to
connect the chimney flue pipe to the fireplace. (see drawing D2.14)
- Once the chimney flue pipe is placed, you must place the flue cover of the chimney,
which is manufactured in two parts (two halves) and join them together. (see drawing D2.15
). You must move this flue cover upwards by sliding it over the telescope (see drawing
D2.16), to allow it to position and screw the support frame, and make the connection
between the chimney and the telescopic. For this fixation, 12 screws with tightening nuts are
supplied. You must make sure the correct position of the support frame. The support frame
is height adjustable in 10 cm intervals (see drawings D2.17 and D2.18).
D2.15 D2.16
18
D2.17 D2.18
METALLIC FIREPLACES
D2.12
D2.13