Change Of The End Positions - Selve SEZ Notice

Setting of the end positions

4.5.4. Change of the end positions

It is quite enough to use a normal shutter switch to change only one limit
position.
or
E
You can also use the SELVE setting switch item no 290103.
Step 1
Move to the end position to be changed.
• Change lower end position
or
or
• Change upper end position
Step 2
Push the button for 10 seconds.
• Change lower end position
or
10 s
or
• Change upper end position
10 s
Step 3
Push the button for four times for 3 seconds each.
• Change lower end position
4x 3 s with 3 s
pause
or
4x 3 s with 3 s
pause
or
• Change upper end position
Push and hold the DOWN button until
the motor stops on its own.
Push and hold the UP button until the
motor stops on its own.
Push the DOWN button for
10 seconds.
Push the UP button for 10 seconds.
Push the DOWN button for 3 seconds,
then release it,
pause for 3 seconds.
Push the DOWN button for 3 seconds,
then release it,
pause for 3 seconds.
Push the DOWN button for 3 seconds,
then release it,
pause for 3 seconds.
Push the DOWN button for 3 seconds,
then release it.
Push the UP button for 3 seconds,
then release it,
pause for 3 seconds.
Push the UP button for 3 seconds,
then release it,
pause for 3 seconds.
Push the UP button for 3 seconds,
then release it,
pause for 3 seconds.
Push the UP button for 3 seconds,
then release it.
33
EN
EN