Installation and electrical connection
3. Installation and electrical connection
Caution! Risk of injury through an electric shock!
Connection only when deenergised!
Run the motor only after installation.
Warning!
3.1. Installation of the motor into a shaft
1. Crown and coupling adapter need to be determined according to the size of the
shaft (picture 1).
2. Push the crown adapter over the shaft and position it precisely on the motor
head.
3. Slide the coupling and plugin the coupling locking device (picture 2).
Picture 1: Examples for different shaft sizes
4. Push the motor into the shaft in a positivelocking way. The motor must not be
subject to any impacts. Crown and coupling adapters must not have any play
inside the shaft.
5. Where required, secure the motor axially, e.g. by screwing the shaft
to the coupling adapter. Do not drill holes into the motor area!
6. Attach the shaft with the motor and the shaft cap in the bearings. Do not bend
the motor cable and place it so that it cannot be damaged. To keep water from
getting into the motor, place the motor line in a bend direction downwards, so
that any water can drip off.
7. Attach the curtain to the shaft.
Picture 2: Coupling locking device
25
EN
EN