Setting Of The End Positions; Delivery Status; Setup Functions - Selve SEL Plus Notice De Réglage

GB

Setting of the end positions

4. Setting of the end positions

4.1. Delivery status

In the SELVE delivery status no end positions or transmitters are programmed into
the motor! In this state, the motor can be operated in deadman's operation only.
Safety functions such as obstacle detection are deactivated at delivery and will only
become active after both end positions are set.
The SEL Plus and SES motors are in automatic setup-mode.

4.2. Setup functions

The end positions setting of a SELVE motor is possible via:
• any standard switch (in automatic mode)
• the setting switch for electronic motors (item no. 290103, manual setup-mode)
When connecting the setting switch for motors, consider the following:
Caution! Risk of injury through an electric shock!
Connection only when de-energised!
Warning!
The 4 wires in the setting switch cable must be connected to the motor wiring cable
according to their colours.
PE = yellow-green
N = blue
UP = brown
DOWN = black
LED indicates connection in correct phase sequence
Pushbutton E is the setting pushbutton
Pushbutton for moving the motor up and down
26