Selve SEZ Notice page 34

EN Setting of the end positions
Step 4
or
Step 5
or
Step 6
or
Push and hold the button.
• Change lower end position
or
• Change upper end position
The motor moves away from the end position and stops on its own.
Move to the new end position with UP or DOWN. Correction is possible.
Note: Only in this programming step there will be no automatic deactiva­
tion!
• Change lower end position
or
• Change upper end position
• Change lower end position
or
• Change upper end position
Push and hold the DOWN button.
Push and hold the UP button.
Do not coil the fabric the wrong way
around.
Do not move the drop rod against the
fabric shaft.
Push and hold the UP button and run
without interruption until the motor
switches off on its own in the upper
end position.
Push and hold the DOWN button and
run without interruption until the motor
switches off on its own in the lower
end position. Done!
34