Selve SEZ Notice page 23

Contents
Dear Customer,
by purchasing a SELVE electronic motor you have decided in favour of a quality product
from the SELVE company. This instruction manual describes the installation and ope­
ration of the motor. Make sure to read this handbook before initial operation of the
SELVE motor and adhere to the safety instructions.
After publication of the operating instructions, SELVE shall not be liable for any changes
to norms and standards! Subject to change without prior notice!
1. Safety instructions ............................................................................................. 20
2. Information about the motor features .............................................................. 24
2.1. Designated use ............................................................................................ 24
2.2. Basic motor properties .............................................................................. 24
3. Installation and electrical connection .............................................................. 25
3.1. Installation of the motor into a shaft ......................................................... 25
3.2. Supporting the motors ............................................................................... 26
3.3. Assembly and disassembly of the pluggable cable ................................. 27
3.4. Electric connection ..................................................................................... 27
4. Setting of the end positions .............................................................................. 28
4.1. Delivery status ............................................................................................. 28
4.2. Setup functions ........................................................................................... 28
4.3. Mechanic requirements ............................................................................. 28
4.4. Setting of the end positions with setting switch/switch .......................... 29
4.5. Selection table for setting .......................................................................... 29
4.5.1. Automatic setup-mode ....................................................................... 30
4.5.2. Manual setup-mode, two fixed points............................................. 31
4.5.3. Manual setup-mode, drive upwards against the limit stop ........... 32
4.5.4. Change of the end positions ............................................................ 33
5. Reset with setting switch and switch ............................................................... 35
6. Technical data .................................................................................................... 36
7. General declaration of conformity ................................................................... 37
8. Troubleshooting ................................................................................................. 37
9. SELVE Service Hotline ....................................................................................... 37
23
EN
EN