Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

EN Setting of the end positions

4.5.1. Automatic setup-mode

 in operation bottom position, top stop/release
When the movement is interrupted twice during operation, the system is in automatic
setup­mode. The drive SEZ is finding the end points in the upper and lower end position
automatically.
Important: A limit stop for the upper and lower end limit is necessary!
First the upper end limit has to be run­up to. From there move against the lower limit
stop without interruption, until the motor is automatically switched off.
Setting with
Setting with
switch
setting switch
E
or
Drive
Move the motor upwards with the UP or DOWN
button. The correct rotation direction assignment
will be carried out at the end of the end position
setting.
The motor moves against the upper stop and
stops automatically.
Continue to push the pushed button or push one of
the motion buttons again. The motor automatically
moves downwards.
The motor will reach the lower limit and stops
automatically.
The end positions are now set and the rotation
direction assignment is correct. Perform a test
run.
30

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Se pro

Table des Matières