MINN KOTA ULTREX Instructions D'installation page 9

5
ITEM(S) NEEDED
#6 x 6
j. Put a 1/4-20 x 2 1/2" Screw (Item #4) in each of
the drilled locations. The Screw should pass through
the Mount Plate and the boat deck.
k. Place a Flat Washer (Item #5) and then a Nylock
Nut (Item #6) at the end of each screw as shown
and secure. Make sure all hardware is secure.
NOTICE:
To prevent seizing of the stainless steel
hardware, do not use high speed installation tools.
Wetting the screws or applying an anti-seize may help
prevent seizing.
Installing the Gas Spring Pin
1
a. Position the motor to the stowed position with the
Pull Grip and Cable to disengage the latch bar,
allowing the motor to fold into a flat position.
b. Once in the stowed or flat position, the Gas Spring
Pin and Spacers can be installed.
©2021 Johnson Outdoors Marine Electronics, Inc.
#5 x 6 #4 x 6
INSTALLING THE GAS SPRING PIN
Screw Screw
Deck Deck
Flat Washer Flat Washer
and Nylock Nut and Nylock Nut
minnkotamotors.com | 9