MINN KOTA ULTREX Instructions D'installation page 31

2
NOTICE:
The Universal Sonar Cable may not be
long enough to reach the fish finder. If the cable
length does not reach the desired fish finder
installation location, a 14.5' extension cable is
available to purchase. Minn Kota recommends
using the MKR-US2-11.
d. Take the Universal Sonar Extension Cable, if
needed, and attach it to the Universal Sonar Cable
exiting the Control Head. Firmly push the plug
together and twist the locking collar until it is snug.
e. Install the Universal Sonar Cable that exists the
Control Head or the Universal Sonar Extension
Cable (if used) to the appropriate Universal Sonar
Adapter Cable. Install the Adapter Cable to your fish
finder. Refer to your fish finder manual for complete
installation instructions.
NOTICE:
If any cables need to be routed, please
follow the guidelines in the Routing Connection
Cables section of these installation instructions.
i-Pilot Link
i-Pilot Link allows your Minn Kota trolling motor and Humminbird to
communicate with each other to change the way you fish. i-Pilot Link
delivers a large array of GPS capabilities including controlling speed,
steering, Spot-Lock, and the ability to record and retrace paths on the water, all at your fingertips. To learn more about the GPS
capabilities available with your i-Pilot Link navigation system, please refer to the Owner's Manual by visiting minnkotamotors.com.
The i-Pilot Link remote and controller make up the i-Pilot Link navigation system. The i-Pilot Link remote comes paired to the controller
from the factory. The i-Pilot Link controller contains a very sensitive compass and is where all GPS satellite and i-Pilot Link remote signals
are received. The i-Pilot Link controller is contained in the trolling motor Control Head and is connected to a fish finder from a connection
cable that exits the Control Head.
The Ethernet cable for the i-Pilot Link system has an 8 pin connector. The i-Pilot Link system can be connected directly to the
Humminbird or to the Humminbird Ethernet Switch (optional). If you purchase an Ethernet Switch, install it using the instructions
included in the Ethernet Installation Guide. A 30' Ethernet Extension Cable has been included with every motor equipped with i-Pilot
Link. It may or may not be needed for every installation. To purchase Ethernet switches, Ethernet cables, and extension cables, visit the
web site humminbird.com
your Humminbird fish finder, an additional ethernet adapter cable
may be required for the installation. Refer to your fish finder operations manual or see the
with a list of all compatible Humminbird Units and SD Cards.
©2021 Johnson Outdoors Marine Electronics, Inc.
FEATURE OvERvIEW AND CONNECTING THE CABLES
or call Humminbird Customer Service at 1-800-633-1468. Depending on the shape of the Ethernet port on
2d
Four Pin Connector Four Pin Connector
Locking Collar Locking Collar
Universal Sonar Universal Sonar
Cable from Cable from
Trolling Motor Trolling Motor
NOTICE:
The connectors are keyed to prevent
reversed installation.
2e
Locking Collar Locking Collar
Universal Sonar Cable from Universal Sonar Cable from
Trolling Motor OR Universal Trolling Motor OR Universal
Sonar Extension Cable Sonar Extension Cable
NOTICE:
The i-Pilot Link system needs an external wired
connection. The i-Pilot system does not need an external
wired connection.
(Ethernet Adapter Cable AS EC QDE #720074-1 for Helix fish
i-Pilot Link Compatibility Chart
Universal Sonar Universal Sonar
Extension Cable Extension Cable
Universal Sonar Universal Sonar
Adapter Cable to Adapter Cable to
fish finder fish finder
finders)
on our web site
minnkotamotors.com | 31