MINN KOTA ULTREX Instructions D'installation page 10

INDEXING THE MOTOR
2
ITEM(S) NEEDED
#25 x 2
c. Locate the upper Gas Spring Pin (Item #27) and
Spacers (Item #26) in the bag assembly. Align the
end of the Gas Spring with the holes in the Outer Arm.
d. Install the Gas Spring Pin through the Outer Arm,
then through a Spacer, the end of the Gas Spring
Cylinder and another Spacer.
NOTICE:
Spacers are placed on each side of the Gas
Spring on the inside of the Outer Arm. Phillips Screws
have a pre-applied thread locker. Do not apply additional
thread-locker to them as it may prevent future removal.
e. Install one Phillips Screw (Item #25) on each end
of the Gas Spring Pin and secure with two #3
Phillips screwdrivers.
f. Tighten Phillips Screws until the heads are flush
with the Outer Arm.
Indexing the Motor
It is recommended to have the Pedal Control Sleeve Assembly pointing inboard. If the Pedal Control Sleeve Assembly points outboard,
please see Orientate the Pedal Control Sleeve Assembly for a Starboard Mount. Use the following instructions to index the motor if the
Pedal Control Sleeve Assembly is already mounted inboard.
Once installed, the system is properly indexed when the motor is deployed and the head of the motor and lower unit align with the
centerline or keel of the boat at the same time the top of the Foot Pedal is parallel to the deck of the boat.
Inboard
Keel Keel
10 | minnkotamotors.com
#26 x 2 #27 x 1
Control Head Control Head
Pedal Control Pedal Control
Sleeve Assembly Sleeve Assembly
Deck of Deck of
Boat Boat
Phillips Screw Phillips Screw
Gas Spring Pin Gas Spring Pin
Spacer Spacer
Outer Arm Outer Arm
Outer Arm Outer Arm
Gas Gas
Spacer Spacer
Spring Spring
Cylinder Cylinder
Phillips Screw Phillips Screw
Outboard
Deck of Deck of
Boat Boat
Keel Keel
Gas Spring Gas Spring
Cylinder Cylinder
Outer Outer
Arm Arm
Spacer Spacer
Gas Gas
Spring Spring
Spacer Spacer
Outer Outer
Phillips Phillips
Arm Arm
Screw Screw
Pedal Control Pedal Control
Sleeve Assembly Sleeve Assembly
©2021 Johnson Outdoors Marine Electronics, Inc.