MINN KOTA ULTREX Instructions D'installation page 33

INSTALLING THE PROP
1
ITEM(S) NEEDED
#7 x 1
CAUTION
Disconnect the motor from the battery before beginning any
prop work.
a. Take the Drive Pin (Item #10) and slide it through
the Hole in the Armature Shaft. Position the Drive
Pin horizontal by grasping the Armature Shaft and
rotating it with the Drive Pin in place.
b. Align the Propeller (Item #7) so it is also horizontal
and parallel with the Drive Pin. Slide the Propeller
onto the Armature Shaft and Drive Pin until it is
seated against the lower unit.
c. Install the Prop Washer (Item #8) and the Prop Nut
(Item #9) onto the end of the Armature Shaft.
d. Holding the end of the Armature Shaft with a Flat
Blade Screwdriver, tighten the Prop Nut with a 9/16"
Open End Wrench.
e. Tighten the Prop Nut 1/4 turn past snug to
25-35 in-lbs.
CAUTION
Do not over tighten as this can damage the prop.
©2021 Johnson Outdoors Marine Electronics, Inc.
#9 x 1
#8 x 1
#10 x 1
1a
Drive Pin Drive Pin
Prop Washer Prop Washer
1b
1d
Prop Nut Prop Nut
Prop Washer Prop Washer
Propeller Propeller
INSTALLING THE PROP
Armature Armature
Shaft Shaft
Propeller Propeller
Prop Nut Prop Nut
Drive Pin Drive Pin
minnkotamotors.com | 33
Propeller Propeller