MINN KOTA ULTREX Instructions D'installation page 14

INDEXING THE MOTOR
8
k. Reconfirm that the Steering Cables are tight and
then carefully thread the Steering Motor Connection
Wire through the top of the Wrap Drum Cover. The
male plug comes from the Cable Anchor through
the opening at the bottom of the Wrap Drum Cover.
The wire with the female plug that runs out the top
of the Cable Gear should also be pulled through the
opening at the bottom of the Wrap Drum Cover.
CAUTION
Take care not to pinch the Steering Motor Connection Wire
while the Wrap Drum is set into place.
9
l. Place the Wrap Drum Cover down on top of the
Cable Anchor and align the screw holes on it with
the screw holes on the Cable Anchor. Make sure the
Wrap Drum Cover is nested securely on top of the
Steering Module and that the wires pass out the top
of the Wrap Drum Housing. Secure the Wrap Drum
Housing in place with the two screws that were
originally removed using a #1 Phillips screwdriver.
Tighten to 6 in-lbs.
10
m. Reconnect the Steering Motor Connection Plug and
push it into the Wrap Drum Cover.
CAUTION
Wires and plug must not touch moving parts. Wires may be
damaged if caught in moving parts.
n. Orientate the wires connecting the Steering Motor
Connection Plug as noted so that the wires do not
touch moving parts.
o. Replace the Connector Cover.
14 | minnkotamotors.com
Wrap Drum Wrap Drum
Cover Cover
Cable Cable
Anchor Anchor
Screws Screws
Wrap Drum Wrap Drum
Cover Cover
Wires Wires
Steering Motor Steering Motor
Connection Connection
Plug Plug
Wires Wires
Wrap Drum Wrap Drum
Cover Cover
Steering Motor Steering Motor
Connection Wire Connection Wire
Steering Steering
Module Module
©2021 Johnson Outdoors Marine Electronics, Inc.