MINN KOTA ULTREX Instructions D'installation page 15

ORIENTATE THE PEDAL CONTROL SLEEvE ASSEMBLY FOR A STARBOARD MOUNT
Orientate the Pedal Control Sleeve Assembly for a Starboard Mount
By default, the Pedal Control Sleeve Assembly is factory set so that when your Ultrex is installed on the port side of your boat, the
Pedal Control Sleeve Assembly points inboard. Should you choose to install your Ultrex on the Starboard side of your boat, it is
recommended that the default mounting location be changed so that the Pedal Control Sleeve Assembly points inboard.
Once the Mount is installed, the system is properly calibrated when the motor is deployed and the head of the motor and lower unit
align with the centerline or keel of the boat at the same time the top of the Foot Pedal is parallel to the deck of the boat.
Use the following instructions to change the mounting location of the Pedal Control Sleeve Assembly on the Steering Housing and then
properly align the head of the motor. If your motor was installed on the Port side of the boat, please disregard these instructions and
see the Indexing the Motor section of this manual.
1
a. Aligning the head of the motor before correcting the
placement of the Pedal Control Sleeve Assembly will
help calibrate alignment once the assembly is in the
recommended position. Turn the Power Switch "on"
and steer the motor so that the Control Head is in
line with the keel of the boat. This can be done by
steering the motor with the Foot Pedal, turning the
motor with the remote, or manually turning the head
of the motor.
b. Leave the motor in the desired alignment and turn
the power to the Foot Pedal "off". Then disconnect
the power by removing the power cables from the
battery or turning "off" the breaker if equipped.
WARNING
To avoid electric shock, make sure the motor is not
connected to a power source.
©2021 Johnson Outdoors Marine Electronics, Inc.
1a
Deck of Deck of
Boat Boat
Keel Keel
1b
Foot Pedal Foot Pedal
Power Switch Power Switch
Pedal Control Pedal Control
Sleeve Assembly Sleeve Assembly
minnkotamotors.com | 15