MINN KOTA ULTREX Instructions D'installation page 11

1
a. Turn the Power Switch "on" and steer the motor so
that the Control Head is in line with the keel of the
boat. This can be done by steering the motor with
the Foot Pedal, turning the motor with the remote,
or manually turning the head of the motor.
b. Leave the Control Head in the desired alignment
and turn the power to the Foot Pedal "off". Then
disconnect the power by removing the power
cables from the battery or turning "off" the breaker
if equipped.
WARNING
To avoid electric shock, make sure the motor is not
connected to a power source.
2
c. Remove the Connector Cover from the Wrap
Drum Cover using a 1/8" wide Flat Screwdriver to
release it. Release it by pressing the flat part of the
screwdriver in the slot closest to the center of the
Connector Cover and prying upwards.
d. Once the Connector Cover is removed, very carefully
disconnect the Steering Motor Connection Plug that
is visible.
Steering Motor Connection Plug Steering Motor Connection Plug
2d
Wrap Drum Wrap Drum
Cover Cover
©2021 Johnson Outdoors Marine Electronics, Inc.
Keel Keel
Foot Pedal Foot Pedal
Power Switch Power Switch
2c
Connector Connector
Cover Cover
NOTICE:
Please note the orientation and routing of the
plug and wires for re-installation.
INDEXING THE MOTOR
Control Control
Head Head
Pedal Control Pedal Control
Sleeve Assembly Sleeve Assembly
Control Head Control Head
Alignment Alignment
Deck of Deck of
Flat Flat
Screwdriver Screwdriver
Wrap Drum Wrap Drum
Connector Connector
Cover Cover
Cover Cover
minnkotamotors.com | 11
Boat Boat