MINN KOTA ULTREX Instructions D'installation page 32

FEATURE OvERvIEW AND CONNECTING THE CABLES
1
a. Place the motor in the deployed position.
b. The i-Pilot Link connector from the Control Head
is an 8 pin connector. Locate and identify the
correct connection for i-Pilot Link, at the base of
the Control Head.
NOTICE:
i-Pilot Link will be paired with either
Built-in MEGA Down Imaging or Universal Sonar
on Ultrex, Ulterra or Terrova. i-Pilot Link is not a
feature offered on Fortrex motors.
NOTICE:
Paired with a Universal Sonar connector
for illustration purposes. A Built-in MEGA Down
Imaging connector may be present instead.
2
ITEM(S) NEEDED
c. If necessary, to reach the installed fish finder, take
the i-Pilot Link Ethernet Cable (Item #24) and attach
it to the i-Pilot Link cable exiting the Control Head.
NOTICE:
If any cables need to be routed, please
follow the guidelines in the Routing Connection
Cables section of these installation instructions.
d. Install the i-Pilot Link Ethernet Cable directly into
the Humminbird fish finder, or refer to your fish
finder installation manual for complete installation
instructions. If an Adapter Cable is needed (Ethernet
Adapter Cable AS EC QDE for Helix fish finders),
install it on the end of the i-Pilot Link Ethernet
Cable and refer to your fish finder installation
manual for complete installation instructions.
32 | minnkotamotors.com
#24 x 1
Control Control
Coil Coil
Head Head
Cord Cord
Mount Mount
Eight Pin Eight Pin
Connector Connector
Locking Locking
i-Pilot Link Ethernet i-Pilot Link Ethernet
Collar Collar
Cable from Trolling Motor Cable from Trolling Motor
NOTICE:
The connectors are keyed to prevent
reversed installation.
i-Pilot Link i-Pilot Link
Built-in MEGA Built-in MEGA
Down Imaging or Down Imaging or
Universal Sonar Universal Sonar
i-Pilot i-Pilot
Link Link
i-Pilot Link Ethernet i-Pilot Link Ethernet
Extension Cable OR Extension Cable OR
Ethernet Extension Cable Ethernet Extension Cable
©2021 Johnson Outdoors Marine Electronics, Inc.