MINN KOTA ULTREX Instructions D'installation page 22

MOUNTING THE FOOT PEDAL
4
h. Replace the Bottom Bumper on the Aluminum Rod,
opposite from the threads.
i. Thread the Aluminum Rod into the Stabilizer Bracket
with the Bottom Bumper towards the boat deck.
j. Adjust the Aluminum Rod up or down in the
Stabilizer Bracket so that the Bottom Bumper just
touches the support surface.
CAUTION
Adjusting the Aluminum Rod too tightly removes the end
play needed for proper latch pin engagement and doing so
could prevent the mount from fully latching in the stowed
position. Improper latching may cause damage. If installed
correctly, the tip of the Aluminum Rod should lift off of the
boat deck about 1/4" without the mount unlatching.
5
k. Once in the correct position, tighten the Jam Nut
upwards against the Stabilizer Bracket. This will
prevent the Aluminum Rod from turning.
l. Install the Top Bumper if there are threads exposed
on the Aluminum Rod above the Stabilizer Bracket.
Mounting the Foot Pedal
We recommend securing the Foot Pedal to the boat deck to
prevent it from being damaged during transport and to make
motor operation more efficient. It is recommended to use the
Mounting Holes on the Foot Pedal for a secure mount. The Foot
Pedal has three Mounting Holes. One Mounting Hole is located
under the Heel End of the Foot Pedal. The other two are located
under the Toe End of the Foot Pedal. We recommend using a
1/8" or 3/16" diameter screw and only tighten enough to slightly
compress the Bumper Pads underneath the Foot Pedal.
22 | minnkotamotors.com
Stabilizer Bracket Stabilizer Bracket
Stabilizer Stabilizer
Bracket Bracket
Heel End Heel End
Mounting Mounting
Holes Holes
Jam Nut Jam Nut
Aluminum Rod Aluminum Rod
Bottom Bottom
Bumper Bumper
Top Bumper Top Bumper
Jam Nut Jam Nut
Toe End Toe End
Mounting Mounting
Holes Holes
Bumper Pad Bumper Pad
©2021 Johnson Outdoors Marine Electronics, Inc.