Assembling The Motor; Connecting The Power Supply - Bosch Rexroth CSS/B Mode D'emploi

16 Bosch Rexroth AG
WARNING!

6.10 Assembling the motor

See the separate assembly instructions 3 842 540 847 enclosed with the motor.

6.11 Connecting the power supply

Electric shock due to contact with live parts
Severe injuries or death.

Do not touch live parts

Before working on the electrical installation, switch off the power supply and
protect it against being switched on again.
Select the control and sensor elements taking into account the load to be transported
and transportation speed in accordance with EN ISO 13849.
The motor must be connected by a specialist!
Observe regulation VDE 0100 for Germany or the appropriate regulations for the
country where the product is used.
6.11.1 Motor connection
Note the existing line voltage!
Note the electrical voltages on the motor type plate, see Fig. A.
Connect the motor as a Y-connection or triangle connection in accordance with the
connection plans, see Fig. B, and the connection plan in the terminal box.
The motor is equipped with a bi-metal switch (potential-free thermal contact,
230 V AC, 300 mA) to monitor the temperature. The motor must be connected in
such a manner that it is currentless when the switch is actuated.
Select a cable entry that prevents damage to the cable during operation.
Connection cable option: 3 842 410 191 (M20x1.5), see Fig. C. Pay attention to the
ballast fuse!
TS 2pv 3 842 540 837 (2010.02)