Everlasting STAGIONATORE Instructions Pour L'utilisateur page 25

SEASONING
2.2 PRODUCT CONFIGURATION
The appliance is designed solely for the preservation of food products (see heading 4.1).
The products must be stored in observance of the load limits shown in the table and in figure 1 in order to ensure efficient air circu-
lation inside the appliance.
limiti di carico in mm
Tipo
L H P
P
L
700-1500 530 1500 650
H
2.3 POWER OUTPUT AND ABSORBED POWER
Technical data for power output and absorbed power are in the enclosed
"Instruction and Maintenance Manual", Table 1.
2.4 NOISE LEVEL
The noise level of the appliance is below 70 dB (A).
2.5 MATERIALS AND REFRIGERANTS
Materials in contact or potentially in contact with food products are in compliance with the relevant directives. The appliance is
designed and built so that food contact parts can be cleaned before each use. The refrigerants utilized (R404A,) comply with esta-
blished regulations (see table 1 in the "Instruction and Maintenance Manual" enclosed).
Section 3 INSTALLATION
3.1 TRANSPORT AND HANDLING
The appliance must be transported and handled exclusively in a vertical position, in observance of the instructions printed on the
packing.
This precaution is necessary to avoid contamination of the refrigerant circuit with compressor lube oil with resulting valve and heat
exchanger coil failure and problems starting the electric motor.
The manufacturer accepts no responsibility for problems due to transport executed in conditions other than those specified above.
The accessories supplied with the appliance (runners, wire shelves, basins, trays, remote condenser with connection pipes) are
supplied in separate packs shipped inside or separately from the unit.
The appliance is secured to a wooden base by means of screws (fig.2) and wrapped in polyethylene or packed in a carton, cage or
crate.
Refer to heading 3.6 for information on correct disposal of packing material.
The appliance must be handled using a fork lift truck or a pallet truck with suitable forks (fork length at least equal to 2/3 length of
unit).
Sizes and masses of packed units are reported in Table 1 in the "Instruction and Maintenance Manual" enclosed.
Maximum permissible stacking and the position of the centre of gravity are shown on the information label on the packing.
25