Lubricate The Front Casters; Cutting Height Adjustment - Briggs & Stratton Snapper PRO SS200 Serie Manuel D'utilisation

Lubricate the Front Casters

Interval: Annually
1. Remove the 1/4-28 bolt (A, Figure 29) screwed into the
caster and install a 1/4-28 grease fitting.
29
2. Grease the front caster.
3. Remove the 1/4-28 grease fitting and reinstall the 1/4-28
bolt.
4. Repeat the process for the other side of the machine.

Cutting Height Adjustment

The cutting height is adjustable between 1-3/4" (4,5 cm) and
5" (12,7 cm) in 1/4" (0,64 cm) increments. Figure 30 depicts
the cut height plate and the cut height decal for the unit. This
figure is intended to help you better understand the available
cutting heights for this unit.
30
To set the cutting height at 1-3/4" (4,5 cm):
1. Pull the deck lift lever (A, Figure 31) back towards the
operator position until it locks into the 5" (12,7 cm)
TRANSPORT position.
31
2. Remove the cutting height adjustment pin (B) from the
hole that it is installed in and put it in the storage location
hole (C, Figure 31 or A, Figure 30).
3. Pull the deck lift lever back towards the operator position
and depress the deck lift release button (D, Figure 31) to
release the transport position lock.
4. Push the deck lift lever forward until it contacts the
stationary pin in the 1-3/4" (4,5 cm) hole.
To set the cutting height in the range of 2" (5,08 cm) and
4-3/4" (12,1 cm):
1. Pull the deck lift lever back towards the operator position
until it locks into the 5" (12,7 cm) TRANSPORT position.
2. Place the cutting height adjustment pin in the desired
cutting height hole.
3. Pull the deck lift lever back towards the operator position
and depress the deck lift release button to release the
transport position lock.
4. Push the deck lift lever forward until it contacts the cutting
height adjustment pin.
To set the cutting height at 5" (12,7 cm):
1. Pull the deck lift lever back towards the operator position
until it locks into the 5" (12,7 cm) TRANSPORT position.
2. Place the cutting height adjustment pin in any open hole.
The deck lift lock latch (E) holds the mower deck at the
5" (12,7 cm) position while cutting.
25