Check Engine Oil Level; Briggs & Stratton Vanguard Engines With Remote Oil Tank (Select Models); Disposing Of Used Engine Oil; Engine Maintenance - Briggs & Stratton Snapper PRO SS200 Serie Manuel D'utilisation

20
2. Fill the fuel tank to the bottom of the filler neck (A, Figure
21). This will allow for fuel expansion. If you are filling the
tank from a fueling station make sure that the nozzle is
inserted into the tank far enough that the splash guard (B)
contacts the opening of the filler neck.
Note: Do not overfill. Refer to your engine owner's manual for
specific fuel recommendations.
21
3. Install and hand tighten the fuel cap.
NOTICE
Refer to your engine owner's manual for specific fuel
recommendations.

Check Engine Oil Level

Interval: Before Each Use
Refer to the engine owners manual for dipstick and oil fill
locations and specific engine oil check and fill procedures.
22
Briggs & Stratton Vanguard Engines
with Remote Oil Tank (Select Models)
Some models in this series of mower feature a remote oil tank
(A, Figure 22) that supplies oil to the engine. Units equipped
with a Vanguard engine with remote oil tank are factory filled
with specially formulated Vanguard 15W-50 synthetic oil.
Note: This specific grade of oil is not required to keep engine
warranty in effect.
For more information regarding this engine and other
operational and maintenance information, please refer to the
engine operator's manual included with your unit.
22

Disposing of Used Engine Oil

Used oil is a hazardous waste product and must be discarded
correctly. Do not discard with household waste. Check with
your local authorities, service center, or dealer for safe
disposal and recycling facilities.

Engine Maintenance

For engine maintenance schedules and procedures, please
refer to the engine operator's manual.
Electronic Fuel Injection (EFI) System -
EFI Models
EFI is an electronically-controlled fuel management system
which is monitored by an Electronic Control Unit (ECU). A
Malfunction Indicator Lamp (M.I.L.) will illuminate if problems
or faults are detected. Servicing by an authorized dealer is
necessary.
CAUTION
Do not disconnect or reconnect ECU wiring harness
connector or any individual components with the ignition
switch in the "ON" position. This can send a damaging
voltage spike through the ECU.
Unplug harness from ECU before performing any welding
on equipment.
snapperpro.com