Briggs & Stratton Snapper PRO SS200 Serie Manuel D'utilisation page 24

• parking brake lever shaft.
• lower parking brake shaft.
• mower deck hanger linkages.
• mower deck spindles.
Use grease fittings when present. Disassemble parts to apply
grease to moving parts when grease fittings are not installed.
Not all greases are compatible. Red grease (p/n 5022285)
is recommended, automotive-type, high-temperature, lithium
grease may be used when this is not available.
The operator platform and suspension pivot bearings (A,
Figure 28) are greased at the factory and do not require
maintenance.
Oil ( ):
• ground speed control and parking brake lever pivots
• deck lift pivots
• discharge chute hinge.
Generally, all moving metal parts should be oiled where
contact is made with other parts. Keep oil and grease off belts
and pulleys. Remember to wipe fitting and surfaces clean
both before and after lubrication.
25
24
26
27
28
snapperpro.com