Raise And Lower The Operator Support Cushion; Fuse Location And Identification; Check / Fill Transmission Oil Level; Checking Tire Pressures - Briggs & Stratton Snapper PRO SS200 Serie Manuel D'utilisation

Raise and Lower the Operator Support
Cushion
This unit is equipped with a hinged operator support cushion
(A, Figure 23) which can be raised to gain access to the
service components underneath the control tower. Raise
the operator support cushion to gain access to the service
components underneath the control tower and lower the
operator support cushion for normal operation. A block of
wood can be used to support the operator support cushion in
the upright position while servicing the components beneath
the control tower.
23

Fuse Location and Identification

The electrical system for this unit is equipped with two
replaceable fuses. See the chart below for the circuit,
amperage, and approximate location of the fuses.
Circuit Amperage
Main 20 amp
PTO Clutch 15 amp

Check / Fill Transmission Oil Level

Oil Type: SAE 20W-50 motor oil
This unit is equipped with two transmission oil tanks (A,
Figure 24). One transmission oil tank only supplies oil to one
transmission. The level of oil in both transmission tanks must
be checked, and if necessary, filled.
24
1. Locate the transmission oil tanks. The transmission oil
2. Check the oil level when the unit is cold. The oil should be
3. Before removing the tank cap (C), make sure that the
4. Add oil up to the "FULL COLD" mark.
5. Re-install the tank caps.
6. After adding oil to the tanks, it may be necessary to purge

Checking Tire Pressures

Tire pressure should be checked periodically, and maintained
at the levels shown in the Specifications chart. Note that
these pressures may differ slightly from the "Max Inflation"
stamped on the side-wall of the tires. The pressures shown
provide proper traction and extend tire life.
Approximate
Location
Mounted by the battery
box on the right hand
side of the machine.
Mounted under the
control panel on the
right hand side of the

Lubrication

machine
Lubricate the unit at the locations shown in
Figures 25, 26, 27, and 28 as well as the following lubrication
points:
Grease (
• front caster wheel axles and yokes.
• deck lift pivot blocks.
• deck lift lever pivot block.
tanks are located on the right side of the engine between
the engine and the battery box.
up to the "FULL COLD" mark (B) on the transmission oil
tanks. If the oil is below this level, proceed to step #3.
area around the tank caps and fill neck of the tank is free
of dust, dirt, and other debris. Remove the tank caps.
air from the hydraulic system. If the unit is not driving
properly perform the Purging the Air from the Hydraulic
System procedure.
):
23