Operation; Before First Time Operation; Checks Before Starting - Briggs & Stratton Snapper PRO SS200 Serie Manuel D'utilisation

Fast throttle speed.
Slow throttle speed.
PTO (Power Take Off) Switch: The PTO switch
engages and disengages the mower blades. Pull UP on the
switch to engage, and push DOWN to disengage.
Ignition Switch: The ignition switch starts and stops the
engine, it has three positions:
OFF: Stops the engine and shuts off the electrical system.
RUN: Allows the engine to run and powers the electrical
system.
START: Cranks the engine for starting.
Note: Never leave the ignition switch in the RUN position with
the engine stopped—this drains the battery.
Fuel Level Gauge: Displays the fuel level in the tank.
The fuel level gauge is installed in the top of the fuel tank and
is viewed by looking through the port hole in the instrument
control panel.

Operation

Before First Time Operation

• Be sure to read all information in the Operator
Safety and Operation sections before attempting to
operate this unit.
• Become familiar with all of the controls and how to stop
the unit.
• Drive in an open area without mowing to become
accustomed to the unit.
WARNING
• Never operate on slopes greater than 17°.
• Select slow ground speed before driving onto a slope.
Use extra caution when operating on slopes with any
collection accessories attached to the unit.
• Mow across the face of slopes, not up and down, use
caution when changing direction on slopes and do NOT
start or stop on a slope.
WARNING
• Never allow passengers to ride on the unit.
• Before leaving the operator's platform for any reason,
engage the parking brake, disengage the PTO, stop the
engine, and remove the key.
• To reduce fire hazard, keep the engine, unit, and
mower deck free of grass, leaves, and excess grease.
Do NOT stop or park unit over dry leaves, grass, or
combustible materials.
• Fuel is highly flammable and must be handled with
care. Never fill the tank when the engine is still hot from
recent operation. Do NOT allow open flame, smoking,
or matches in the area. Avoid over-filling and wipe up
any spills.
WARNING
Do NOT load this zero-turning mower on a trailer or truck
using two separate ramps. Only use a single ramp that is at
least one foot wider than the width of the rear wheels of this
unit. This unit has a zero turning radius and the rear wheels
could fall off the ramps, or the rider could tip over injuring
the operator or bystanders.

Checks Before Starting

• Check that the crankcase is filled to the full mark on
the crankcase oil dipstick. If necessary, add oil through
the engine oil fill. See the engine operator's manual
for instructions, the location of the engine oil fill and oil
dipstick, and oil recommendations.
• Make sure all nuts, bolts, screws and pins are in place
and tight.
• Fill the fuel tank with fresh fuel. Refer to engine manual
for fuel recommendations.
• Check the hydraulic oil level.
15