Briggs & Stratton Snapper PRO SS200 Serie Manuel D'utilisation page 13

5
Cutting Height Adjustment Pin
Storage Hole for Cutting Height Adjustment Pin
Deck Lift Lock Lever
Maximum Forward Speed Bar: This unit is equipped with an
adjustable Maximum Forward Speed Bar (A, Figure 6), which
is located in front of the Ground Speed Control Levers (B &
C).
6
The Maximum Forward Speed Bar can be adjusted in three
different positions to suit the desired maximum forward speed
of the operator. The positioning hole closest to the ground
speed control levers (labeled as #1 in Figure 6) is the lowest
setting and the positioning hole furthest from the ground
speed control levers (labeled as #3) is the fastest.
To adjust the position of the Maximum Forward Speed Bar
pull the T-handle knob (D) out to release the maximum
forward speed bar, position the Maximum Forward Speed Bar
in the desired location, and then release the T-handle knob.
Make sure that the T-handle knob locks the maximum forward
speed bar into place.
You should only adjust the position of the Maximum
Forward Speed Bar after you have stopped all movement
of the unit.
Ground Speed Control Levers: These levers control the
ground speed of the unit. The left lever (B, Figure 6) controls
the left rear drive wheel and the right lever controls (C) the
right drive wheel.
FORWARD
NEUTRAL
REVERSE
Moving a lever forward increases the FORWARD speed of
the associated wheel, and pulling back on a lever increases
the REVERSE speed.
The ground speed control levers cannot be moved from the
NEUTRAL position until the parking brake lever is moved to
the DISENGAGED position.
Note: The further a lever is moved away from the neutral
position the faster the drive wheel will turn.
See Driving the Zero-Turn Riding Mower section for steering
instructions.
Parking Brake: Pull the parking brake lever rearward
and up to engage the parking brake. Move the lever fully
forward and down to disengage the parking brake.
Disengage
Engage
Operator Platform: The operator stands on the operator
platform while driving the machine. Keep both feet on the
operator platform at all times.
The operator platform is integral to the safety interlock
system:
Releases the parking brake.
Locks the parking brake.
13