Features And Controls; Control Functions And Locations; Unit Controls - Briggs & Stratton Snapper PRO SS200 Serie Manuel D'utilisation

Test 1 - Engine should NOT crank if:
• The parking brake lever is in the DISENGAGED position.
Test 2 - Engine SHOULD crank if:
• The parking brake lever is in the ENGAGED position.
Test 3 - Engine should SHUT OFF if:
• The ignition switch is turned to the OFF position.
Test 4 - PTO Switch (blades) should SHUT OFF if:
• If the PTO switch is ON and the operator steps off the
operator platform, OR
• The operator presses the PTO switch down to the OFF
position.
Test 5 - PTO Switch (blades) SHOULD turn on if:
• Operator stands on the operator platform and the PTO
switch is pulled up to the ON position.
Test 6 - Blade Brake Check:
Mower blades and mower drive belt should come to a
complete stop within seven (7) seconds after electric PTO
switch is turned off (or operator steps off the operator
platform). If the mower drive belt does not stop within seven
(7) seconds, see your dealer.
Note: Once the engine has been stopped, the parking brake
lever must be in the ENGAGED position, the ground speed
control levers should be in the NEUTRAL position, the
operator should be standing on the operator platform, and the
PTO switch should be in the OFF position in order to start the
engine.
WARNING
If the unit does not pass a safety test, do NOT operate it.
See your authorized dealer. Under no circumstance should
you attempt to defeat the purpose of the safety interlock
system.

Features and Controls

Control Functions and Locations

The information below briefly describes the function of
individual controls. Starting, stopping, driving, and mowing
require the combined use of several controls applied in
specific sequences. To learn what combination and sequence
of controls to use for various tasks see the Operation section.
12

Unit Controls

4
A. Deck Lift Lever, Cutting Height Adjustment Pin, and
Deck Lift Release Button
B. Maximum Forward Speed Bar
C. Ground Speed Control Levers
D. Parking Brake
E. Transmission Oil Fill (Transmission Oil Reservoirs)
F. Battery Box
G. Fuel Tank Cap
H. Operator Platform
I. Transaxle Release Levers (Located behind Operator
Support Cushion)
Deck Lift Lever, Cutting Height Adjustment Pin, and Deck
Lift Release Button: The deck lift lever (B, Figure 5), cutting
height adjustment pin (A), and deck lift release button (C) are
used together to control the cutting height of the mower deck.
See Cutting Height Adjustment for instructions on using these
controls.
snapperpro.com