Yamaha WR450F Manuel D'atelier Du Proprietaire page 556

Å
ı
FRONT BRAKE AND REAR BRAKE
5 - 26
2. Air bleed:
Brake system
G
Refer to "BRAKE
BLEEDING" section in the CHAPTER
3.
3. Inspect:
Brake fluid level
G
Fluid at lower level → Fill up.
Refer to "BRAKE
INSPECTION" section in the CHAP-
TER 3.
4. Install:
[Front]
Reservoir float
G
Diaphragm
G
Master cylinder cap 1
G
Screw (master cylinder cap) 2
G
2 Nm (0.2 m · kg, 1.4 ft · lb)
[Rear]
Diaphragm
G
Master cylinder cap 1
G
Bolt (master cylinder cap) 2
G
2 Nm (0.2 m · kg, 1.4 ft · lb)
CAUTION:
After installation, while pulling the lever in
or pushing down on the pedal, check
whether there is any brake fluid leaking
where the union bolts are installed respec-
tively at the master cylinder and caliper.
Å Front
ı Rear
5. Install: (rear brake only)
Protector 1
G
Bolt (protector) 2
G
7 Nm (0.7 m · kg, 5.1 ft · lb)
CHAS
SYSTEM AIR
FLUID LEVEL