Yamaha WR450F Manuel D'atelier Du Proprietaire page 520

FRONT WHEEL AND REAR WHEEL
5 - 8
Rear wheel
1. Install:
Bearing (right) 1
G
Circlip 2 New
G
Spacer 3
G
Bearing (left) 4
G
Oil seal 5 New
G
NOTE:
Apply the lithium soap base grease on the
G
bearing and oil seal lip when installing.
Install the bearing with seal facing outward.
G
Use a socket that matches the outside diam-
G
eter of the race of the bearing.
Right side of bearing shall be installed first.
G
Install the oil seal with its manufacture's
G
marks or numbers facing outward.
CAUTION:
Do not strike the inner race of the bearing.
Contact should be made only with the outer
race.
2. Install:
Brake disc 1
G
Bolt (brake disc) 2
G
14 Nm (1.4 m · kg, 10 ft · lb)
NOTE:
Tighten the bolts in stage, using a crisscross
pattern.
3. Install:
Driven sprocket 1
G
Bolt (driven sprocket) 2
G
Plain washer (driven sprocket) 3
G
Nut (driven sprocket) 4
G
50 Nm (5.0 m · kg, 36 ft · lb)
NOTE:
Tighten the nuts in stage, using a crisscross
pattern.
CHAS