Yamaha WR450F Manuel D'atelier Du Proprietaire page 212

Masquer les pouces Voir aussi pour WR450F:

Table des Matières

ENGINE OIL REPLACEMENT

6. If the oil filter is to be replaced during this

oil change, remove the following parts

and reinstall them.

Replacement steps:

Remove the oil filter cover 1 and oil filter

Check the O-rings 3, if cracked or dam-

aged, replace them with a new one.

Install the oil filter element and oil filter

Oil filter cover:

10 Nm (1.0 m • kg, 7.2 ft • lb)

Plain washer 1

Oil strainer (frame) 2

70 Nm (7.0 m · kg, 50 ft · lb)

Engine oil hose 3

Bolt (engine oil hose) 4

8 Nm (0.8 m · kg, 5.8 ft · lb)

Engine oil hose clamp 5

2 Nm (0.2 m · kg, 1.4 ft · lb)

Engine skid plate

10 Nm (1.0 m · kg, 7.2 ft · lb)

Oil filter drain bolt

10 Nm (1.0 m · kg, 7.2 ft · lb)

Drain bolt (crankcase rear)

20 Nm (2.0 m · kg, 14 ft · lb)

Drain bolt (crankcase left)

10 Nm (1.0 m · kg, 7.2 ft · lb)

Drain bolt (frame)

23 Nm (2.3 m · kg, 17 ft · lb)

Oil quantity:

Periodic oil change:

1.0 L (0.88 Imp qt, 1.06 US qt)

With oil filter replacement:

1.1 L (0.97 Imp qt, 1.16 US qt)

Total amount:

1.2 L (1.06 Imp qt, 1.27 US qt)