Yamaha WR450F Manuel D'atelier Du Proprietaire page 460

a
1
b
c
AC MAGNETO AND STARTER CLUTCH
1
2
2. Install:
Holder 1
G
Bolt 2
G
NOTE:
Pass the pick-up coil lead 3 and AC mag-
G
neto lead 4 under the holder as shown.
Take care not to catch the AC magneto lead
G
between crankcase cover ribs.
Apply the sealant to the grommet of the AC
G
magneto lead.
Quick gasket
ACC-QUICK-GS-KT
YAMAHA Bond No. 1215:
90890-85505
3. Install:
Starter clutch drive gear 1
G
Starter clutch 2
G
NOTE:
Apply the engine oil on the starter clutch drive
gear inner circumference.
4. Install:
Woodruff key 1
G
Rotor 2
G
NOTE:
Clean the tapered portions of the crankshaft
G
and rotor.
When installing the woodruff key, make sure
G
that its flat surface a is in parallel with the
crankshaft center line b.
When installing the rotor, align the keyway c
G
of the rotor with the woodruff key.
4 - 80
ENG
7 Nm (0.7 m · kg, 5.1 ft · lb)

: