Degassing Programmes - Overview; Setting Degassing Programmes - Reflex Servimat M Mode D'emploi Original

Controller
9.3.4 Degassing programmes – overview
i
You can choose between 2 degassing programs:
Continuous degassing
• Usage:
– For device commissioning.
– For degassing of the water after a device or facility system repair.
• Activation:
– An automatic activation occurs after completion of the start routine
during initial commissioning.
• Times:
– The time can be set in the Customer menu.
– The default setting is 24 hours. Subsequently, the system
automatically switches to Interval degassing.
In continuous degassing, the degassing cycles are sequentially performed for 24
hours.
Continuous degassing is pre-set in the customer menu as the default setting.
Interval degassing
• Usage:
– For continuous operation of the device.
• Activation:
– Automatic activation occurs after the ending of continuous
degassing.
• Times:
– 8 degassing cycles per interval is set in the Service menu.
– After 8 intervals there is an idling time of 24 hours.
– The times for interval degassing are stored in the Service menu.
– Daily start of interval degassing is at 8:00 a.m.
 Note!
Manual activation of the degassing program takes place in the customer
menu.
9.3.5

Setting degassing programmes

1. Press "Settings".
– The controller switches to the setting area.
2. Press "Customer >".
– The controller opens the Customer menu.
3. Press "Degassing >".
– The controller switches to the selected area.
– Use the scroll bar to navigate through the list.
20 — English
4. Press "(012) Degassing programme".
– The controller opens the list of degassing programmes.
5. Press the desired button.
–
– Confirm your selection with "OK".
– Degassing is deactivated.
6. Press "(013) Time, continuous degassing".
7. Set the time for continuous degassing.
– Use the "Left" and "Right" buttons to select the display value.
– Use the "Up" and "Down" buttons to change the display value.
– Confirm your entries with "OK".
Press "i" to display a help text for the selected area.
Press "X" to cancel your input without saving the new settings. The
controller automatically opens again the list.
Servimat M/L — 28.01.2021
"Continuous degassing" is selected in this example.
No degassing and interval degassing are deselected.