Service Menu; Default Settings - Reflex Servimat M Mode D'emploi Original

PM code Description
029 • Maximum make-up quantity ... l
030 • Softening "Yes/'No"
– If "Yes", continue with 031
– If "No", continue with 007
007 Maintenance interval... months
008 Floating contact
• Message selection >
• Message selection: only messages marked with "√" are
output.
• All messages: All messages are output.
015 Change remote data "Yes/No"
Fault memory > History of all messages
Parameter memory > History of parameter input
Display settings > Brightness, screen saver
009 • Brightness ... %
010 • Screen saver brightness ... %
011 • Screen saver delay ...min
018 • Secure access "Yes/No"
Information >
• Tank
• Volume
• Weight
• Diameter
Position motorized ball valve 1
• Software version
9.3.1.2 Setting the customer menu - "Time" example
The setting of system-specific values is explained below using the setting of the
time as example.
To adjust the system-specific values, proceed as follows:
1. Press "Settings".
– The controller switches to the setting area.
2. Press "Customer >".
– The controller opens the Customer menu.
3. Press the required area.
– The controller switches to the selected area.
– Use the scroll bar to navigate through the list.
4. Set the system-specific values for the individual areas.
–
–
–
Press "i" to display a help text for the selected area.
Press "X" to cancel your input without saving the new settings. The
controller automatically opens again the list.
9.3.2

Service menu

This menu is protected with a password. It can be accessed only by the Reflex
Customer Service. A partial summary of the settings stored in the Service menu is
proved in the Chapter Default settings, see chapter 9.3.3 "Default settings" on
page 19 .
9.3.3

Default settings

The device controller is shipped with the following default settings. Use the
Customer menu to adjust these values to local conditions. In specific cases, it is
possible to further adjust the values in the Service menu.
Customer menu
Parameter
Language
Minimum operating
pressure P
0
Safety valve, pressure
Next maintenance
Volt-free contact
Make-up
Maximum make-up
quantity
Maximum make-up time
Maximum make-up
cycles
Degassing
Degassing programme
Continuous degassing
time
Softening (Only if "With
softening yes")
Lock make-up
Hardness reduction
Maximum make-up
quantity
Soft water capacity
Cartridge replacement
Servimat M/L — 28.01.2021
Use the "Left" and "Right" buttons to select the display value.
Use the "Up" and "Down" buttons to change the display value.
Confirm your entries with "OK".
Setting
EN
1.5 bar
3.0 bar
12 months
YES
0 Litres
20 minutes
3 cycles within 2
hours
Continuous
degassing
24 hours
No
8°dH
0 Litres
0 Litres
18 months
Controller
Remarks
Display language
Only Magcontrol
Pressure value for the safety
valve of the heat generator in the
system to trip
Time left to the next due
maintenance
All messages from the Messages
list are displayed
Only if controller with "With
water meter yes"
Magcontrol
Magcontrol
In the case of soft water residual
capacity = 0
= Target – Actual
Attainable make-up quantity
Attainable water capacity
Replace cartridge
English — 19